1/2" NOM (5/8" OD) x 3/8" COMP 1/4 Turn Angle Stop Valve 10 Pack

Miiflex Heavy Duty Chrome Plated Brass 1/4 Turn Angle Stop Valve 1/2" NOM (5/8" OD) COMP x 3/8" COMP Less Ferrule and Nut

This (10) pack heavy duty, single-mold cast body, 1/4 turn angle stop valve is the solution to a long lasting, dependable shut-off valve for use in for your residence, commercial properties, and all places that require an angle shut-off valve 3/8-in OD compression. Every valve is leak-free quality controlled by the factory during the manufacturing process. For use in potable and non-potable plumbing and water distribution systems.

[VALUE] This product comes in a contractor 10 pack, less ferrule and nut, to provide you multiple installs in your entire house or project.

[PREMIUM QUALITY] This heavy duty product was crafted in a single-mold body design with premium quality lead-free brass that can withstand harsh usage and repetition while maintaining its integrity and long-lasting durability. High quality stainless steel ball valve inside. The zinc-plated arrowhead valve lever adds a modern appearance and practical use to the valve.

[VERSATILITY] These angle stop valves are great for residential DIYers, renovators, or plumbers, or for commercial projects such as schools, office buildings, apartments, hotels, or public buildings.

[APPLICATIONS] Use as water control shut off valves for kitchen sinks, bathroom vanities, dishwasher, toilets, basins, water filtration systems, etc.

[COMPLIANCE] High quality, shiny chrome-plated brass made from lead free compliant material and certified by UPC.

Disclaimer:

These angle valves are without ferrule and nut on the "OUT" end. The package may say 5/8" OD COMP but it is the same as 1/2" NOM copper.

Note to installer:

This heavy duty valve is machined and crafted with very high precision and leaks after installs are very rare. If leaks do occur, most likely it is due to incorrect install method. Follow this guidance during install:

- DO NOT reuse old compression ring and nut. Remember to remove existing ring and nut from previous valve as this may cause improper seal and potential catastrophic flood to the property.

- DO NOT overtighten the nut as this will deform the compression ring and cause a leak.

- DO NOT use on copper stub-out that has been deformed or has uneven surface.

Product Disclaimer:

P65 warning requires products sold in the State of California to display a warning label indicating any traces of chemicals known to the State to cause birth defects or other reproductive harm. Although this product is listed as "lead free/low lead", it only pertains to the material of the area where potable water runs through/touches. Other areas such as the handle may still have minute traces of lead and has to be indicated per P65 Warning.